pgm554
asked on
Exchange 2010 sp level?
When I run a bpa ,it says sp3 avail for exchange 2010.
I pretty sure I installed it ,but I don't know rollup level and I see it's at 6.
Any easy way to tell ru level?
I pretty sure I installed it ,but I don't know rollup level and I see it's at 6.
Any easy way to tell ru level?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
It's saying 14.1 and I'm almost positive I installed sp3.
This type of stuff from M$ makes me nervous.
This type of stuff from M$ makes me nervous.
Exchange service packs are relatively straight forward, just make sure you prepare properly and it will involve some loss of service so schedule a good few hours of downtime.
I've found a guide that goes through every step pretty clearly so follow this and you should be alright.
Don't forget to take the opportunity to install update rollup 5 for SP3 after installing the SP.
http://exchangeserverpro.com/installing-exchange-server-2010-service-pack-3/
M@
I've found a guide that goes through every step pretty clearly so follow this and you should be alright.
Don't forget to take the opportunity to install update rollup 5 for SP3 after installing the SP.
http://exchangeserverpro.com/installing-exchange-server-2010-service-pack-3/
M@
ASKER
>update rollup 5 for SP3 ?
I'm seeing ru 6 out there for 2010 sp3.
So sp3 is not cumulative(includes rollups)?
And the ru must be applied separately?
I'm seeing ru 6 out there for 2010 sp3.
So sp3 is not cumulative(includes rollups)?
And the ru must be applied separately?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
The service packs are not updated but the the Roll Ups are cumulative so you can go to ru6 after upgrading to sp3
ASKER
Still working
Open in new window
and hit enter. This will list all your servers and their 'AdminDisplayVersion' if this is Version 14.3 then you have exchange 2010 SP3, if any are 14.2 then that server only has SP2M@