trojan81
asked on
ASA 9.1 SYNTAX
Experts,
ON 9.1 I created a network object
fw(config)# object network obj-test1234
fw(config-network-object)# host 1.1.1.1
fw(config-network-object)# host 2.2.2.2
Now within the CLI I want to be able to see the contents of the object. I can't get the syntax correct. I'm trying:
sh run object network id obj-test1234
sh object-group network obj-test1234
ON 9.1 I created a network object
fw(config)# object network obj-test1234
fw(config-network-object)#
fw(config-network-object)#
Now within the CLI I want to be able to see the contents of the object. I can't get the syntax correct. I'm trying:
sh run object network id obj-test1234
sh object-group network obj-test1234
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.