• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 2672
  • Last Modified:

SCCM Device Collection based on IP Address

Hello

I need to use SCCM to push out an application package only to computers that are based at a particular site.

IP address should be the best way to do this, and I have created a query (see attached screenshot), but it is picking up some systems that have multiple IP addresses.  e.g. a computer that has been at the site and gets a 172.26.201.x address but also another site 172.26.202.x

Have I setup the query correctly?  Also, will this collection auto update?  I.e if a computer comes into the site from elsewhere, and gets the correct IP address, how long for the collection to update and push the package?

Thanks in advance
ScreenHunter-62-Aug.-26-16.22.jpg
ScreenHunter-63-Aug.-26-16.23.jpg
0
Wolf
Asked:
Wolf
1 Solution
 
Nagendra Pratap SinghCommented:
Perhaps use a security group/OU. This is manual but will work even with multiple addresses.
0
 
merowingerCommented:
The Clients normally keep their IP for at least a week (if Default DHCP assigned).
As far as i know the IP Information Comes with the heartbeat discovery cycle which by default is once a week also.
Soif you limit the update Intervall of the collection to a few hours, or days or should be good to go.
The query Looks not bad, but you could aso use the Subnet Paramter so you can query for '172.26.201'
0

Featured Post

Simplify Active Directory Administration

Administration of Active Directory does not have to be hard.  Too often what should be a simple task is made more difficult than it needs to be.The solution?  Hyena from SystemTools Software.  With ease-of-use as well as powerful importing and bulk updating capabilities.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now