?
Solved

create a cisco access rule on a firewall

Posted on 2014-09-03
4
Medium Priority
?
144 Views
Last Modified: 2014-09-14
Hi there

I just want to add a simple access rule that map a public IP address to a private IP in the DMZ using port 22 only.

How can I do that from scratch?

Many thanks
0
Comment
Question by:Mustafa Osman
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
4 Comments
 
LVL 25

Expert Comment

by:Ken Boone
ID: 40301155
What version of software are you running on the ASA?  The commands to do this are different depending on if you are on 8.2 and below or 8.3 and above.

Thank you.
0
 
LVL 57

Accepted Solution

by:
Pete Long earned 1500 total points
ID: 40301212
0
 

Author Comment

by:Mustafa Osman
ID: 40301347
What command line should I use to find out what version the firewall is running or is it the show running config?
0
 
LVL 25

Expert Comment

by:Ken Boone
ID: 40301367
show version
0

Featured Post

Enroll in August's Course of the Month

August's CompTIA IT Fundamentals course includes 19 hours of basic computer principle modules and prepares you for the certification exam. It's free for Premium Members, Team Accounts, and Qualified Experts!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Powerful tools can do wonders, but only in the right hands.  Nowhere is this more obvious than with the cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

770 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question