Solved

Increase VPN user allowance - Cisco 2801

Posted on 2014-09-04
1
49 Views
Last Modified: 2015-08-26
I have a Cisco 2801 tht I use at work as a VPN concentrator - lately I have been having problems as I seem to be exceeding some sort of VPN session or user count. It seems to be about 25 users/sessions.  I have proved this out by maxing it out and then dropping one connection and then another VPN user can log on.   How do I increase this VPN sessions limit?  What commands do I use to see and increase the count.

My searchs haven't produced anything.

THanks

Marcus
0
Comment
Question by:msmaby
1 Comment
 
LVL 11

Accepted Solution

by:
marek1712 earned 500 total points
ID: 40308747
What kind of VPN protocol do you use? SSL? If yes - there's an answer to the limit: LINK.
By installing AIM module you can get up to 50 connections: LINK.
Have you considered switching to the IPSec?
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

821 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question