Solved

VDC communiation

Posted on 2014-09-14
4
76 Views
Last Modified: 2014-10-12
Hi,

How to configure to communicate one VDC to other and what are the Troubleshooting commands to
diagnose if any issues between VDC's

Regards
Ram
0
Comment
Question by:RAMU CH
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
  • 2
4 Comments
 
LVL 50

Accepted Solution

by:
Don Johnston earned 500 total points
ID: 40322867
You will need to use a physical cable to allow one VDC to communicate with another.
0
 
LVL 1

Author Comment

by:RAMU CH
ID: 40327183
what is the up-Link configuration between two VDC's , Is L3 IP reachability configuration or L2 Trunk configuration?

Can i assume it's a kind of inter-vlan communication in catalyst switches for communication between two different domain?

Regards
Ramu
0
 
LVL 50

Expert Comment

by:Don Johnston
ID: 40327658
what is the up-Link configuration between two VDC's , Is L3 IP reachability configuration or L2 Trunk configuration?
It can be whatever type of link you need it to be.
0
 
LVL 1

Author Closing Comment

by:RAMU CH
ID: 40376381
Thanks
0

Featured Post

Transaction Monitoring Vs. Real User Monitoring

Synthetic Transaction Monitoring Vs. Real User Monitoring: When To Use Each Approach? In this article, we will discuss two major monitoring approaches: Synthetic Transaction and Real User Monitoring.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Monitoring a network: how to monitor network services and why? Michael Kulchisky, MCSE, MCSA, MCP, VTSP, VSP, CCSP outlines the philosophy behind service monitoring and why a handshake validation is critical in network monitoring. Software utilized …
Add bar graphs to Access queries using Unicode block characters. Graphs appear on every record in the color you want. Give life to numbers. Hopes this gives you ideas on visualizing your data in new ways ~ Create a calculated field in a query: …

707 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question