Still celebrating National IT Professionals Day with 3 months of free Premium Membership. Use Code ITDAY17

x
?
Solved

how to configure dynamic ARP inpection on cisco switch

Posted on 2014-09-17
3
Medium Priority
?
472 Views
Last Modified: 2014-09-19
what commands do I need to configure Dynamic ARP Inspection on my Cisco switch?
0
Comment
Question by:tygurr61
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 

Author Comment

by:tygurr61
ID: 40329516
What commands are needed to configure Dynamic ARP Inspection (DAI) on a Cisco switch?
thanks
0
 
LVL 3

Accepted Solution

by:
Soufiane Adil, Ph.D earned 2000 total points
ID: 40330813
Hi

if your are  in a DHCP Environment

Switch(config)# interface GigabitEthernet1/0/1
Switch(config-if)# ip arp inspection trust
Switch(config)# ip arp inspection vlan 5-10

if you are not in a DHCP Environment
Switch(config)# arp access-list arpacl
Switch(config-arp-acl)# permit ip host 10.1.1.11 mac host 0011.0011.0011
Switch(config-arp-acl)# exit
Switch(config)# ip arp inspection filter arpacl vlan 5
Switch(config)# interface GigabitEthernet1/0/2
Switch(config-if)# no ip arp inspection trust

Sou
0

Featured Post

Moving data to the cloud? Find out if you’re ready

Before moving to the cloud, it is important to carefully define your db needs, plan for the migration & understand prod. environment. This wp explains how to define what you need from a cloud provider, plan for the migration & what putting a cloud solution into practice entails.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
This month, Experts Exchange’s free Course of the Month is focused on CompTIA IT Fundamentals.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
In this brief tutorial Pawel from AdRem Software explains how you can quickly find out which services are running on your network, or what are the IP addresses of servers responsible for each service. Software used is freeware NetCrunch Tools (https…

715 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question