mikeg95
asked on
Cisco WAP 551 Setup | DHCP
I have two Cisco WAP 551 Access points. replacing two ingenuous AP's.
I connect the AP's over POE and did the set up wizard locally from my laptop straight to AP.
once i connect to the network it turns on and broadcasts its SSID but does not hand out IP's to anyone who connects.
Also the LAN port does not light up.
What am I missing. it has an IP and it will even get on if I tell it to pick it up via DHCP but it doesn't go past there. I need this up ASAP please
I connect the AP's over POE and did the set up wizard locally from my laptop straight to AP.
once i connect to the network it turns on and broadcasts its SSID but does not hand out IP's to anyone who connects.
Also the LAN port does not light up.
What am I missing. it has an IP and it will even get on if I tell it to pick it up via DHCP but it doesn't go past there. I need this up ASAP please
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER