Solved

Cisco Dialer Interface Spoofing

Posted on 2014-09-29
2
553 Views
Last Modified: 2014-10-02
[del]
downloadmundra01_tro···hoot.txt 8,595 bytes
Hello Community,

I'm having a little problem configuring our router to connect via PPPoE. Everything appears to configured ok, however I'm getting the following from the Dialer Interface:
Dialer 1 is up (Spoofing), line protocol is up (spoofing).

I understand that 'line protocol is up (spoofing)' is normal. However, I don't understand

'Dialer 1 is up (Spoofing)'

I have attached the configs

Any help will be greatly appreciated..
mundra01-troubleshoot.txt
0
Comment
Question by:cpatte7372
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 46

Accepted Solution

by:
Craig Beck earned 500 total points
ID: 40351198
That just means that the virtual interface (the dialer) is pretending to be an actual interface - it is bound to a physical interface so it's pretending to be that interface.

It's perfectly normal.
0
 

Author Closing Comment

by:cpatte7372
ID: 40357060
Cheers
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses
Course of the Month5 days, 21 hours left to enroll

627 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question