samiam41
asked on
Resolve Cisco 2960-x port is error disabled
Greetings Experts. I recently installed several of these 2960-x switches and this one switch has showed an error on port 16. The computer that was plugged into this switch couldn't access the network so it was moved to another port on a different switch and the computer could then access the network. I used express setup on these switches and didn't enable any error disabled settings.
Here is what errdisable recovery command on port 16:
How do I resolve the error for that port?
Thanks in advance for your help experts!
Here is what errdisable recovery command on port 16:
JCAO_FLR2_45#show errdisable recovery
ErrDisable Reason Timer Status
----------------- --------------
arp-inspection Disabled
bpduguard Disabled
channel-misconfig (STP) Disabled
dhcp-rate-limit Disabled
dtp-flap Disabled
gbic-invalid Disabled
inline-power Disabled
link-flap Disabled
mac-limit Disabled
loopback Disabled
pagp-flap Disabled
port-mode-failure Disabled
pppoe-ia-rate-limit Disabled
psecure-violation Disabled
security-violation Disabled
sfp-config-mismatch Disabled
small-frame Disabled
storm-control Disabled
udld Disabled
vmps Disabled
psp Disabled
Timer interval: 300 seconds
Interfaces that will be enabled at the next timeout:
JCAO_FLR2_45#
How do I resolve the error for that port?
Thanks in advance for your help experts!
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Just completed your instructions and the port is clear of errors. Thanks for your help!