Solved

VPN to VPN Traffic

Posted on 2014-11-03
4
245 Views
Last Modified: 2014-12-12
I am trying to connect three sites with vpn tunnels.  Main site is 192.168.1.xx.  Sonicwall to sonicwall site to site vpn to 192.168.200.xx.  Sonicwall to fortinet site to site connecting 192.168.150.xx.  I cannot get the two branches to talk to each other. (192.168.200.xx with 192.168.150.xx).  I know it's a routing issue and/or vpn nat, however I can not figure out the rules.

can anyone help?
0
Comment
Question by:pscanevit
  • 2
  • 2
4 Comments
 
LVL 25

Expert Comment

by:Fred Marshall
ID: 40420628
Point to point or hub and spoke?
0
 

Author Comment

by:pscanevit
ID: 40420640
they are site to site
0
 
LVL 25

Accepted Solution

by:
Fred Marshall earned 500 total points
ID: 40420975
Can you provide the topology.
For example, are the VPN routers also the internet gateways in every case?
If not then one or more is a VPN router and NOT an internet gateway, right?
0
 

Author Closing Comment

by:pscanevit
ID: 40497283
Thank you for your diligence, however the problem was resolved by creating hops.
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

803 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question