Solved

Cisco asa 5512-x how to change the management IP address

Posted on 2014-11-04
2
1,013 Views
Last Modified: 2014-11-05
I need to use 192.168.1.x for an inside network but can't seem to change the default IP of the management interface from 192.168.1.0 to something like 192.168.8.0.

I have tried using the CLI and ASDM to change the management IP to 192.168.8.1. This works partially. I am able to access the ASA via the console cable and use CLI. But a PC/laptop connected to the management port no longer gets a DHCP address. I have tried using a static IP but then ASDM doesn't load on the 192.168.8.1 address.

I assume that the Cisco ASA 5512-x must have a default network setting and DHCP service configured but can't find this is documented any where. This should be the most simplest of things to do but I am not finding the answer. Any help would be greatly appreciated.
0
Comment
Question by:wajordan
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 16

Accepted Solution

by:
max_the_king earned 500 total points
ID: 40424247
Hi,

http 192.168.8.0 255.255.255.0 management

dhcpd address 192.168.8.2-192.168.8.254 management
dhcpd enable management

if necessary, delete old statements regarding management and dhcp on 192.168.1.0

hope this helps
max
0
 

Author Closing Comment

by:wajordan
ID: 40424974
Thanks for your reply. I solved this last night but didn't get a chance to write up with my solution. Essentially I did the same thing but also enabled ASDM access on .8.x network.
0

Featured Post

Technology Partners: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Article by: rfc1180
The Maximum Segment size (MSS) is an important consideration when troubleshooting connectivity via the Internet/Intranet. As the packets are routed via the Internet/Intranet, the packets must traverse through multiple routers in the path between two…
There are times where you would like to have access to information that is only available from a different network. This network could be down the hall, or across country. If each of the network sites have access to the internet, you can create a ne…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

726 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question