beardog1113
asked on
ASA MIB2 compatible
hello Experts
i am configure an ASA snmp then using PRTG to monitor the traffic usage, but from the PRTG i got the following error while connect to it(as attachment), do you know how to fix it?
ASA version is 8.3
thank you
i am configure an ASA snmp then using PRTG to monitor the traffic usage, but from the PRTG i got the following error while connect to it(as attachment), do you know how to fix it?
ASA version is 8.3
thank you
Can you post SNMP configuration from ASA?
Regards!
Regards!
ASKER
ASA-01# sh run | inc snmp
snmp-server host inside 10.10.8.32 community *****
snmp-server location AAA
no snmp-server contact
snmp-server community *****
snmp-server host inside 10.10.8.32 community *****
snmp-server location AAA
no snmp-server contact
snmp-server community *****
Hello, I found similar problem on EE:
http://www.experts-exchang e.com/Netw orking/Net work_Manag ement/Netw ork_Analys is/Q_26703 872.html
So try to check PRTG configuration for that device, I think you need to check some MIB checkboxes under device to work.
http://www.experts-exchang
So try to check PRTG configuration for that device, I think you need to check some MIB checkboxes under device to work.
ASKER
hello
this topic is talking about switch, how i can fix this on the ASA firewall?
thanks
this topic is talking about switch, how i can fix this on the ASA firewall?
thanks
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Also, did you allow SNMP traffic udp/161 in your ACL on firewall?
ASKER
yes, after i reboot the PRTG server and try connect it again and works well, looks like something wrong on PRTG server.
thank you
thank you
ASKER
not sure whats wrong i can't uploading a image.
the error message of PRTG is : "sorry, no MIB2 compatible ports were sound on this device"
thank you