Solved

Mikrotik Rb2011 VPN Not Passing Traffic

Posted on 2014-11-06
2
628 Views
Last Modified: 2014-11-08
I have two RB2011 that I am trying to connect with a site to site VPN.  I have done this before successfully but for some reason I'm missing or forgetting something.

I have the Police,Peer and Proposal setup the same on each router but reversed.  

I had originally set this up in a lab environment and it was working.  So I backed up and restored the configuration to a new router and changed a few parameters such as LAN/WAN addresses and updated the VPN settings.

The VPN appears to be connected but I can not ping across the VPN.

The only thing unique about this setup than other installations I have done is I have two subnets on one of the routers and a firewall rule allowing traffic across the two subnets except it blocks one particular IP.  I tried disabling that rule also and no luck.

Both Routers are on 6.21.1 software.

Any help would be greatly appreciated.
0
Comment
Question by:truth_talker
2 Comments
 
LVL 38

Accepted Solution

by:
Aaron Tomosky earned 500 total points
ID: 40428276
Does the device you are trying to ping have a software firewall blocking pings? Also make sure you have the return routes setup in the other router or the ping can't get back to you.
0
 

Author Comment

by:truth_talker
ID: 40430224
I ended up doing a factory reset on the router and reprogrammed it from scratch and everything started working correctly.
0

Featured Post

Courses: Start Training Online With Pros, Today

Brush up on the basics or master the advanced techniques required to earn essential industry certifications, with Courses. Enroll in a course and start learning today. Training topics range from Android App Dev to the Xen Virtualization Platform.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Secure VPN Connection terminated locally by the Client.  Reason 442: Failed to enable Virtual Adapter. If you receive this error on Windows 8 or Windows 8.1 while trying to connect with the Cisco VPN Client then the solution is a simple registry f…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

776 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question