Solved

issues with cisco asa and Linksys (sit-to-site)

Posted on 2014-11-17
2
138 Views
Last Modified: 2014-11-22
hi all!  configuring ASA firewall for site-to-site vpn with linksys has taken its toll on me.   do i need to create the firewall rules on the ASA?  There is a site-to-site guide from cisco site which is pretty straight forward but still, the linksys would show connected but i am not able to ping either sites... linksys site-to-site with another linksys, no problem.  any insights from anyone would be greatly appreciated.
0
Comment
Question by:mwauki
  • 2
2 Comments
 
LVL 93

Accepted Solution

by:
John Hurst earned 500 total points
ID: 40447101
For Cisco Linksys RV series to non-Cisco routers, I use NAT Traversal for some setups. I do not use Aggressive Mode. These settings are found in the Advanced settings of the Tunnel Setup.

Try NAT Traversal:  Both ends on, One end on, Other end on.
0
 
LVL 93

Expert Comment

by:John Hurst
ID: 40460157
@mwauki  - Thank you and I was happy to help.
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
VIRTUAL NETWORKING 3 77
Receiving wifi on an underground station 22 88
Dlink-DIR 816 router 4 20
can't ssh to external IP 9 16
I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

790 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question