Solved

IPv6 on ASA

Posted on 2014-11-26
5
105 Views
Last Modified: 2014-12-06
I have 2 virtual context on my ASA sharing an interface to communicate with each other.
Context named Test and VPN

Problem is I cannot ping from TEST to VPN context via ipv6.
I don’t have any problems with ping the interface with ipv4.
Please see attached my configs.

I tried this setup on 2 different ASA’s one ASA with code 9 and one with code 9.2.
Only problem is connectivity via ipv6.
What did i do wrong with ipv6 configs.
Configs.log
0
Comment
Question by:ciscosupp
  • 3
5 Comments
 
LVL 22

Expert Comment

by:eeRoot
ID: 40469749
Can you post the relevant sections of the config?  Is the ASA configured with any IP's and rules for allowing ICMP traffic?
0
 

Author Comment

by:ciscosupp
ID: 40470029
Configs are attached????
0
 
LVL 32

Expert Comment

by:harbor235
ID: 40473888
Does your policy allow the IPV6 traffic flows to the ASA?

harbor235 ;}
0
 

Accepted Solution

by:
ciscosupp earned 0 total points
ID: 40474143
The IPv6 neighbor mechanism relies on multicasting and multicasting (ipv4 & ipv6) is not supported on shared interfaces.
Two ways to work around it:
- Define static neighbors. Works fine if you only have 2-3 contexts. Too much work if you need more contexts. You need to setup a full mesh of routes and static neighbors.
- Have some other device in the shared network do routing (router on a stick) for IPv6.
0
 

Author Closing Comment

by:ciscosupp
ID: 40484413
I found the solution.
0

Featured Post

Microsoft Certification Exam 74-409

Veeam® is happy to provide the Microsoft community with a study guide prepared by MVP and MCT, Orin Thomas. This guide will take you through each of the exam objectives, helping you to prepare for and pass the examination.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

How to configure Site to Site VPN on a Cisco ASA.     (version: 1.1 - updated August 6, 2009) Index          [Preface]   1.    [Introduction]   2.    [The situation]   3.    [Getting started]   4.    [Interesting traffic]   5.    [NAT0]   6.…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
As a trusted technology advisor to your customers you are likely getting the daily question of, ‘should I put this in the cloud?’ As customer demands for cloud services increases, companies will see a shift from traditional buying patterns to new…
Both in life and business – not all partnerships are created equal. Spend 30 short minutes with us to learn:   • Key questions to ask when considering a partnership to accelerate your business into the cloud • Pitfalls and mistakes other partners…

832 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question