marrj
asked on
Cisco LWAPP/CAPWAP Not Working
I have a Cisco WLC 2504 and a few 702W LAPs that I am trying to get configured to work together. I cannot seem to get the LWAPP/CAPWAP discovery to work. I've attached the output I get after issuing a "debug capwap packet enable" command.
The WLC's management interface and the LAPs are on the same subnet. No firewalls exist between the two devices. I can ping from the WLC to the LAP and vice versa.
Any ideas what my issue might be?
DEBUG-CAPWAP-PACKET-ENABLE.txt
The WLC's management interface and the LAPs are on the same subnet. No firewalls exist between the two devices. I can ping from the WLC to the LAP and vice versa.
Any ideas what my issue might be?
DEBUG-CAPWAP-PACKET-ENABLE.txt
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I actually stumbled onto my answer about the same time I was reading your response. I did a "debug pm pki enable" and started getting messages about setting the date and time on the controller.
Needless to say, after I set the date to something more realistic (it was January of 2000), CAPWAP started working.
This is a demo controller I received from Cisco.