IBM Host Lun shows repeatedly

Are there multiple network paths configured to this NetApp?  You'll need the MultiPath driver installed if not already.

It is configured. I am having this issue with only vio1 but vio2 is working fine and both are sharing the same Datastore.

Could use a little more info...  Have you tried deleting and recreating this LUN?  Can you read/write to this LUN equally well from both hosts?  If you create a second LUN and connect to both servers, is the same issue present?  Thx

I tried a lot time creating and deleting LUNs. I created two LUNs shared them between VIO1 and VIO2. VIO2 is showing LUN correctly but VIO1 is showing same LUN repeatedly.

This is the way it is showing
Please Suggest!

 FAS01            /vol/vol_axvio/axvio_LUN6 hdisk10         fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN7 hdisk11         fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN6 hdisk12         fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN7 hdisk13         fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN6 hdisk6          fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN7 hdisk7          fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN6 hdisk8          fcs0       FCP        100g    7
 FAS01            /vol/vol_axvio/axvio_LUN7 hdisk9          fcs0       FCP        100g    7

Glad you figured it out.

I solved this.