ciscosupp
asked on
IPv6 on Lightweight AP’s
Cisco lightweight AP’s connect to a WLC but don’t get IPv6 address IPv4 works 100%.
When I plug a PCinto the port where AP is connecting to it gets an IPv6 address via DHCPv6.
Is there any setting on AP I need to enable to have dual stack support.
When I plug a PCinto the port where AP is connecting to it gets an IPv6 address via DHCPv6.
Is there any setting on AP I need to enable to have dual stack support.
AFAIK IPv6 is only supported for clients.
ASKER
My AP’s are AIR-CAP3702P-E-K9 and WLC is 7500 with code 8 they should support ipv6 as i also have an option for CAPWAP IPv6.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.