Solved

vlan IP i get from a AP

Posted on 2014-12-16
5
138 Views
Last Modified: 2014-12-21
I am new to the company and I’m trying to figure out the infrastructure here. I am having hard time finding where my wireless IP is coming from.

I know it’s on VLAN 15. I looked on the core switch which is the vtp server. When I do show run, vlan 15 does not show up. When I do show vlan brief, vlan 15 shows as active. I cannot find anything associated on that switch with the subnet I received when logging into that wireless connection. How else could I get that IP or how can I pin point this? I went to gui of the AP and it’s clearly on vlan 15. When I do show vlan brief on thw switch the AP is connected to, the port does not belong to vlan 15.
0
Comment
Question by:Shark Attack
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 4
5 Comments
 
LVL 11

Expert Comment

by:rharland2009
ID: 40502886
In Aruba implementations, often the APs will tunnel on a single VLAN (like the default or a specified VLAN) back to the controller, where the other VLANs (such as vlan 15) will be reachable. This way, the DHCP packets in the tunnel and give the computer/AP the appropriate address. What kind of wireless gear do you have?
0
 
LVL 3

Author Comment

by:Shark Attack
ID: 40502925
Well, there is no wireless controller, we have an ACS but did not see anything special there. I got an 1130 AP, I have a 3560 L3 core switch and 3560 server switches.
0
 
LVL 3

Author Comment

by:Shark Attack
ID: 40502955
I also searched the entire workbook in excel which we have all the devices on and i did not find anything on the vlan 15 network address, the only thing i found was a ip route
0
 
LVL 3

Accepted Solution

by:
Shark Attack earned 0 total points
ID: 40502963
ahh! i found in. dhcp was configured on the backup firewall.
0
 
LVL 3

Author Closing Comment

by:Shark Attack
ID: 40511434
ahh! i found in. dhcp was configured on the backup firewall.
0

Featured Post

Technology Partners: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Viewers will learn how to connect to a wireless network using the network security key. They will also learn how to access the IP address and DNS server for connections that must be done manually. After setting up a router, find the network security…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

696 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question