?
Solved

configure vwic2-2mft-t1/e1for multilink

Posted on 2014-12-22
1
Medium Priority
?
144 Views
Last Modified: 2014-12-26
I am going to configure a t1 multilink on a vwic2-2mft tomorrow for the first time.  I have never done anything like this so I am a little nervous. Can anyone offer any suggestions or a good place to get the commands?  It is on a 2811 router that will bring the bank branch down till I am done. Thanks in advance for any help.
0
Comment
Question by:Jobeethemage
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 11

Accepted Solution

by:
rharland2009 earned 2000 total points
ID: 40513839
Here's an older post that while referring to an 18xx router, pretty much shows precisely what you need to do.

http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_24809363.html

Short version - assign the serial interfaces to the multilink group, then configure the multilink interface. Pay attention to the T1 pieces to make sure they're identical, etc.
0

Featured Post

WordPress Tutorial 2: Terminology

An important part of learning any new piece of software is understanding the terminology it uses. Thankfully WordPress uses fairly simple names for everything that make it easy to start using the software.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
I had an issue with InstallShield not being able to use Computer Browser service on Windows Server 2012. Here is the solution I found.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses
Course of the Month14 days, 20 hours left to enroll

770 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question