asked on

Cisco Aironet Power Injector Connectivity problem

Hello Guys.

I have got a new Cisco Aironet Power Injector LR2 , and I am trying to connect it through Ethernet and serial port, but none of them is working. I tried with the default IP, with the IP assigned to ... by DHCP server, and even tried to connect on COM ports as was suggested on the Cisco website, any idea what could be the problem?

Ben Hart

Do you have a LAP attached to the coax ports? If so is it powered up?

ITM-IHCC

ASKER

I am trying to connect at the serial port (COM1, COM2), and when I plug in the serial ports, I can see the lights turned on, but still not able to connect,

Ben Hart

I assume that when you do that you are serializing to the AP and not the injector. So if there is no AP connected via the coax's then there'd be no serial either.

Ben Hart

Table 2

AIR-PWRINJ-BLR2
AIR-PWRINJ-BLR2T
Status LEDs
One LED:

•Power Status

Configuration and Management
The power injector does not require configuration or management.

*Taken from http://www.cisco.com/en/US/products/ps5861/products_data_sheet09186a008022551d.html

So I'm still wondering if you have a working AP connected and if it's powered up.

ITM-IHCC

ASKER

So, does it mean that the injector does not have any IP and we cant connect to it visa any web console or putty etc?

ASKER CERTIFIED SOLUTION

Ben Hart

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial