MichaelBalack
asked on
How to setup Cisco AP?
This is using the new Cisco Aironet 2700 series (2702) 802.11ac dual-band access point. It is using POE power supply. However, after power up the AP, I can't access via the console cable. And on the console, it shows "Password required but not set". How to set it up in Lightweight mode?
Thanks in advance.
Thanks in advance.
Lightweight APs require a controller. You don't configure them at the AP's console.
ASKER
Then, that should be in autonomous mode, as it has to be work alone.
Yes.
ASKER
Hi Craigbeck,
Btw, how to convert from lwapp to autonomous?
Btw, how to convert from lwapp to autonomous?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
ok