Member_2_231077
asked on
Dell OMSA clear hardware changes
Have a Dell server with a PV220s on it in split-bus mode. It is working fine but some time in the past the disks had been moved and are still showing up in the old positions on the "hardware changes" tab under OMSA. How do I acknowledge the hardware change so the old disks do not show up with red Xs against them?
Here's a pic...
Here's a pic...
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
I apologize, I misunderstood what part of the program you were in when you received the error. You're looking for the button to acknowledge the hardware changes, and the button is not evident. Obviously, it is suppose to be there. The documentation says it is suppose to be there.
Two possible suggestions:
Try hitting the page with a different browser. (I've had problems in the past with the OMSA page... switching between IE and Firefox will frequently exhibit non-overlapping issues.)
Try upgrading OMSA on that server to a newer version.
Two possible suggestions:
Try hitting the page with a different browser. (I've had problems in the past with the OMSA page... switching between IE and Firefox will frequently exhibit non-overlapping issues.)
Try upgrading OMSA on that server to a newer version.
ASKER
Still don't know what caused it, maybe both paths should have been connected but too dangerous to play with it using live data.
ASKER