Solved

Connect to Cisco Anyconnect that doesn't have a fqdn

Posted on 2015-01-12
2
93 Views
Last Modified: 2015-07-21
Hello, I'm trying to configure remote access on a Cisco ASA 5505 using the Anyconnect. I've followed the steps exactly from: "http://www.techrepublic.com/blog/data-center/eight-easy-steps-to-cisco-asa-remote-access-setup/" but the difference is, I don't a fqdn that I can point users to. So would I and how do I setup a user to access the vpn using our public IP address? Is this even possible?

Thanks,
Brad
0
Comment
Question by:bhodge10
2 Comments
 
LVL 11

Accepted Solution

by:
naderz earned 500 total points
ID: 40546033
Yes, you can use the IP address. FQDN is only to make it easy for reading. Note: In order for the FQDN to work it will have to be resolved to an IP address via DNS. Use the outside interface's IP address.
0
 

Author Comment

by:bhodge10
ID: 40547333
Ok, I redid the steps and only used the public IP of the outside interface as the fqdn as well as the domain for the certificate. That seemed to work, however i tried to enter the command "nat (inside) 0 access-list no_nat" and I get the following message (I believe it's because the steps were created on an older version of the IOS and I'm running 9.22):

"ERROR: This syntax of nat command has been deprecated.
Please refer to "help nat" command for more details."

So long story short, I can connect to the VPN, but now I can't ping anything on my 192.168.72.0 network or access any shared drives. The network for the VPN addresses is 192.168.100.0.  Would this have something to do with the above command not working? Thanks!
0

Featured Post

Highfive Gives IT Their Time Back

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

From Cisco ASA version 8.3, the Network Address Translation (NAT) configuration has been completely redesigned and it may be helpful to have the syntax configuration for both at a glance. You may as well want to read official Cisco published AS…
SSL stands for “Secure Sockets Layer” and an SSL certificate is a critical component to keeping your website safe, secured, and compliant. Any ecommerce website must have an SSL certificate to ensure the safe handling of sensitive information like…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

706 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

19 Experts available now in Live!

Get 1:1 Help Now