paulrausch
asked on
Cisco Voice translation rule question
Quick question for someone with Cisco UC experience.
voice translation-rule 1110
rule 1 /xxxsevendigits/ /121/
rule 2 /xxxsevendigits/ /124/
rule 3 /xxxsevendigits/ /123/
rule 4 /xxxsevendigits/ /401/
rule 5 /xxxsevendigits/ /402/
rule 6 xxxsevendigits/ /126/
rule 7 /xxxsevendigits/ /213/
rule 8 /xxxsevendigits/ /199/
rule 9 /yyysevendigits/ /199/
rule 10 /zzzsevendigits/ /199/
rule 15 /.*/ /199/
used with
voice translation-profile SIPIncoming
transate called 1110
and
dial-peer voice 1110 voip
description Incoming SIP Call
translation-profile incoming SIPIncoming
b2bua
session protocol sipv2
session target ipv4:***.***.***.***
incoming called-number xxx.......
voice-class codec 1
dtmf-relay rtp-nte
no vad
For the last two numbers in the voice-translation rule 1110, they have different area codes.
The DIal-Peer 1110 specifies that incoming called-numbers will start with xxx, but has no inclusion for yyy or zzz.
Can they be added to the rule? If not, should I change the rule to .......... (just 10 dots), or make two new dial peers and voice translation rules for these area code/dids.
Thank you so much,
voice translation-rule 1110
rule 1 /xxxsevendigits/ /121/
rule 2 /xxxsevendigits/ /124/
rule 3 /xxxsevendigits/ /123/
rule 4 /xxxsevendigits/ /401/
rule 5 /xxxsevendigits/ /402/
rule 6 xxxsevendigits/ /126/
rule 7 /xxxsevendigits/ /213/
rule 8 /xxxsevendigits/ /199/
rule 9 /yyysevendigits/ /199/
rule 10 /zzzsevendigits/ /199/
rule 15 /.*/ /199/
used with
voice translation-profile SIPIncoming
transate called 1110
and
dial-peer voice 1110 voip
description Incoming SIP Call
translation-profile incoming SIPIncoming
b2bua
session protocol sipv2
session target ipv4:***.***.***.***
incoming called-number xxx.......
voice-class codec 1
dtmf-relay rtp-nte
no vad
For the last two numbers in the voice-translation rule 1110, they have different area codes.
The DIal-Peer 1110 specifies that incoming called-numbers will start with xxx, but has no inclusion for yyy or zzz.
Can they be added to the rule? If not, should I change the rule to .......... (just 10 dots), or make two new dial peers and voice translation rules for these area code/dids.
Thank you so much,
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Wonderful, thank you. Everything is working.
ASKER