Solved

PowerConnect 55xx VLAN Configuration

Posted on 2015-01-19
1
63 Views
Last Modified: 2016-11-23
Setup as follows:

1x Dell PowerConnect 5500 series switch.  Port 1 is untagged VLAN1 to the router.  Port 2 needs to be tagged only receiving a trunk port connection from another provider's equipment.  Ports 3-48 should have VLAN 1 untagged and VLAN 50 tagged.

The issue is only VLAN 1 untagged data is traversing ports 3-48, no VLAN 50 tagged traffic.  Already verified that the cables plugged into ports 1 and 2 are receiving their respective traffic.  Issue appears to be configuration in the switch.

These are for Cisco phones, we have created the LLDP policies but are unable to see VLAN 50 tagged for the Voice VLAN at the phones when plugged into the Dell switch.  I have assigned the ports as follows:

Port 1: Access VLAN 1 default/pvid
Port 2: Trunk VLAN 50
Ports 3-48: General VLAN 1 Untagged // VLAN 50 Tagged

In the VLAN Port management we are unable to simply click the grid of U/T/F buttons and specify them on the VLANs.  Have to do it manually.

Not quite sure where to go from here?
0
Comment
Question by:Sean Williams
1 Comment
 
LVL 5

Accepted Solution

by:
Armenio earned 500 total points
ID: 40559139
If I'm not mistaken you may need to configure these through the CLI (console ) I find the Gui somewhat limited.

http://sipi.usc.edu/manuals/dell/6024/cli_html/vlan.htm

this may help
0

Featured Post

How Do You Stack Up Against Your Peers?

With today’s modern enterprise so dependent on digital infrastructures, the impact of major incidents has increased dramatically. Grab the report now to gain insight into how your organization ranks against your peers and learn best-in-class strategies to resolve incidents.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
snmp v2 configuration on a switch 3 39
Dell Latitude 6 Series 5 48
Simple Fibre Question 6 33
Windows Update for Skype Meeting App? 1 16
This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
Join Greg Farro and Ethan Banks from Packet Pushers (http://packetpushers.net/podcast/podcasts/pq-show-93-smart-network-monitoring-paessler-sponsored/) and Greg Ross from Paessler (https://www.paessler.com/prtg) for a discussion about smart network …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

735 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question