crp0499
asked on
NAT on Cisco 5515
I'm configuring a new Cisco ASA 5515. I of course have my mgt interface. I went thru the setup wizard and I have my public IP on 0/0 and my LAN IP on 0/1. How do I set up NAT between the two?
I see a place to add a NAT rule, but I'm not quite sure how to do it.
Can anyone either tell me or point me in the direction of a good howto for newbies?
Thanks
Cliff
I see a place to add a NAT rule, but I'm not quite sure how to do it.
Can anyone either tell me or point me in the direction of a good howto for newbies?
Thanks
Cliff
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Did I mention that CLI is not an option?
:)
I'll give it a go. Thanks.
:)
I'll give it a go. Thanks.
ASKER
And do I need one for the other way? Outside in?
No - by default you block all traffic in, (return traffic is allowed)
show version will tell you