Solved

Cisco SG300 Port mirroring - Can the MIRROR TARGET be used as a LAN port as well as a MIRROR port?

Posted on 2015-01-20
1
968 Views
Last Modified: 2015-02-24
Does anyone know if the Cisco SG300 can be used to mirror a network port, where:

1. The SOURCE port is a specific port on the switch (TX and RX)
2. The DESTINATION port is a specific port on the switch
3. The DESTINATION port is also used for the device to access the network?

While I am mirroring, the device in the network port will need to make use of the network.  I am aware that this traffic will be in the capture, but it is necessary to interact with the network while capturing.  I'd rather NOT do this with a 2nd NIC in the system that I'm capturing with....the switch that we WERE using was able to do this (ADTRAN 1234).

Thanks!
0
Comment
Question by:jkeegan123
1 Comment
 
LVL 57

Accepted Solution

by:
giltjr earned 500 total points
ID: 40562065
I doubt it.  No other Cisco switch supports the target of a mirror session to be used as a "normal" LAN port also.
0

Featured Post

MIM Survival Guide for Service Desk Managers

Major incidents can send mastered service desk processes into disorder. Systems and tools produce the data needed to resolve these incidents, but your challenge is getting that information to the right people fast. Check out the Survival Guide and begin bringing order to chaos.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

#Citrix #Citrix Netscaler #HTTP Compression #Load Balance
If your business is like most, chances are you still need to maintain a fax infrastructure for your staff. It’s hard to believe that a communication technology that was thriving in the mid-80s could still be an essential part of your team’s modern I…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
This video gives you a great overview about bandwidth monitoring with SNMP and WMI with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're looking for how to monitor bandwidth using netflow or packet s…

828 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question