sabhawe
asked on
Dell poweredge T610
I'm working on Dell poweredge server it came with 3x146 GB HDD configured with raid 5, they are partitioned C,D,E 60,209,30 GB. I replaced them with 3x900GB HDD configured the with raid 5. With two partition C,D 1TB and 600GB I had a full backup created with windows backup I sneered the windows 2k8 server standred 64bit with SP2
And went to repair then restore from back up I was able to see my backup click on it the I installed the drivers for my H700 integrated PERC controller the started the restore. It went through it ok I got the massage that it was successful and I need to restat when restart it goes as fare as the windows logo then it flash blue screen then restart and continue doing so.
Any help with this please
And went to repair then restore from back up I was able to see my backup click on it the I installed the drivers for my H700 integrated PERC controller the started the restore. It went through it ok I got the massage that it was successful and I need to restat when restart it goes as fare as the windows logo then it flash blue screen then restart and continue doing so.
Any help with this please
Seth Simmons
what is the stop code in the blue screen?
Try to use the last know good configuration
ASKER
Hi Seth: I did take note of the error code:(
And I have moved on from try to restore from that backup because I have been trying for two days now.. I even toke a backup of the system state when I run (wbadmin get versions I get error that say no backup found..! So I installed the operation win2k8
And I'm trying to restore from RDX Quickstore backup.. Any tips.. :)
And I have moved on from try to restore from that backup because I have been trying for two days now.. I even toke a backup of the system state when I run (wbadmin get versions I get error that say no backup found..! So I installed the operation win2k8
And I'm trying to restore from RDX Quickstore backup.. Any tips.. :)
ASKER
Hi tom tried that but no joy.
ASKER
How can I restore my system state I can see the backup folder on my rdx quick store tape 19gb but when I type wbadmin get versions it say no backup found the only thing that might of changed is the tape drive latter I can remember what it was but its I now would that make a deference..?
On the old system ,was there a Dell diag partition by any chance?
If you were using the built in backup,it does not back up any partition other than ntfs ,and I've see weird things occur without that partition.
If you were using the built in backup,it does not back up any partition other than ntfs ,and I've see weird things occur without that partition.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I sorted it out my self.