Solved

Site to Site VPN Tunnel - Cisco ASA

Posted on 2015-01-26
3
199 Views
Last Modified: 2015-01-26
I have an ASA 5000 and I need to set up site to site VPN Tunnel.  I have multiple address inside my network, but in a secquence 111.123.124.13 -15 and 31-35 and 41 - 46  Since they are all basically the same can I get a way with 1 tunnel and all these addresses or do I need to build 14 different tunnels?  I plan on using the GUI for this it's alot easier.
0
Comment
Question by:WellingtonIS
  • 2
3 Comments
 
LVL 94

Accepted Solution

by:
John Hurst earned 500 total points
ID: 40571343
First, if you are trying to access all addresses 111.123.124.xxx (that is all addresses in a subnet), you just need to set up this end with subnet addressing. I do this with Juniper and Cisco RVxx but I have not done it with Cisco ASA. I am sure you can do it.

Second, if you are trying to access very different IP addresses (external) then you would need one tunnel for each.
0
 

Author Closing Comment

by:WellingtonIS
ID: 40571361
Thanks that's what I'm going to do.
0
 
LVL 94

Expert Comment

by:John Hurst
ID: 40571363
@WellingtonIS  - You are very welcome and I was happy to assist.
0

Featured Post

Technology Partners: We Want Your Opinion!

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
VLAN Question 7 43
Edge switch problems cisco 2960 25 48
Clientless VPN Access 23 39
TZ400 VPN Clients 5 23
OpenVPN is a great open source VPN server that is capable of providing quick and easy VPN access to your network on the cheap.  By default the software is configured to allow open access to your network.  But what if you want to restrict users to on…
This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

679 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question