Wyant Niswonger
asked on
I need to direct all outbound calls from an FXS attached device to a specific dial-peer in Cisco Call Manager Express
Hello:
I am trying to direct all of the calls that are initiated on an SCCP controlled FXS port to a specific dial peer. So far I have been unsuccessful. Inbound is fine.
Any thoughts? I am attaching my sanitized config.
The FXS port that I need to redirect is 0/1/0. I need all calls from it to go out dial-peer 1001.
Thanks!
I am trying to direct all of the calls that are initiated on an SCCP controlled FXS port to a specific dial peer. So far I have been unsuccessful. Inbound is fine.
Any thoughts? I am attaching my sanitized config.
The FXS port that I need to redirect is 0/1/0. I need all calls from it to go out dial-peer 1001.
Thanks!
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.