Solved

Enable ICMP Echo and ICMP Echo reply

Posted on 2015-02-09
4
137 Views
Last Modified: 2015-02-10
Hello Expert,
I have to allow the ICMP echo and ICMP echo reply request on all the domain joined desktops in our network, please guide me  how create an appropriate GPO for this scenario, all of my Desktops are placed inside the OU called "NYKComputers" .

I am using windows 2008 Domain controller and all desktops are window 7
 
Regards
0
Comment
Question by:smpvm
  • 2
  • 2
4 Comments
 
LVL 79

Accepted Solution

by:
David Johnson, CD, MVP earned 500 total points
ID: 40598213
computer configuration --> Windows Settings --> System and security --> Windows Firewall --> Advanced settings --> Inbound rules --> New rule --> custom rule
in Protocol and ports: Protocol: ICMPv4,  customize, choose "Specific ICMP types", check the box "echo request"
 next... next... give it a name i.e. "Ping Echo Request" and a description i.e. "respond to ping requests" and save it
0
 

Author Comment

by:smpvm
ID: 40598241
Hello David,
I am going to create this GPO in window 2008 domain controller, can you please advice me is the below steps correct:-
What i am going to do is right click on the specific OU , Create a GPO in this domain and link it here > Computer Configuration > Policies > Windows settings > Security Settings >Windows Firewall with Advance security > Inbound Rules , Under Inbound Rules create New Rule > Custom rule > All programs
is this steps correct ?

waiting for your advice.
0
 
LVL 79

Expert Comment

by:David Johnson, CD, MVP
ID: 40598251
yes that is correct, just keep following the instructions
0
 

Author Closing Comment

by:smpvm
ID: 40600740
Good solution
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

INTRODUCTION The purpose of this document is to demonstrate the Installation and configuration of the Data Protection Manager product. Note that this demonstration was prepared on the basis of Windows OS is 2008 R2 and DPM 2010. DATA PROTECTI…
Issue: One Windows 2008 R2 64bit server on the network unable to connect to a buffalo Device (Linkstation) with firmware version 1.56. There are a total of four servers on the network this being one of them. Troubleshooting Steps: Connect via h…
This tutorial will show how to push an installation of Backup Exec to an additional server in both 2012 and 2014 versions of the software. Click on the Backup Exec button in the upper left corner. From here, select Installation and Licensing, then I…
This tutorial will show how to configure a single USB drive with a separate folder for each day of the week. This will allow each of the backups to be kept separate preventing the previous day’s backup from being overwritten. The USB drive must be s…

777 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question