asked on

Internet connection to LAN via Cisco 800 Series

Hello,

I have a new VSAT installation and I can see the internet when I connect directly to the VSAT modem, however, I am trying to connect to my LAN via a CIsco 800 series router and cannot seem to get the connection working.

My running config is attached, would aprreciate any assistance to identify where I am going wrong.

Thank you.
RunningConfig-10.14.1.1.txt

Predrag Jovic

What is output from
# show ip route
# show vlan

And does host attached to modem use DHCP or static IP (in case of working internet)?

Matt

ASKER

# show ip route results

Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route, H - NHRP, l - LISP
+ - replicated route, % - next hop override

Gateway of last resort is not set

10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 10.14.1.0/24 is directly connected, Vlan1
L 10.14.1.1/32 is directly connected, Vlan1
62.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 62.41.60.16/30 is directly connected, Vlan2
L 62.41.60.18/32 is directly connected, Vlan2

Matt

ASKER

When I ran # show vlan, all I received was 'Command completed successfully.'

ASKER CERTIFIED SOLUTION

Predrag Jovic

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

Matt

ASKER

Thank you, that did the trick.