Solved

dsp module 2811

Posted on 2015-02-11
2
60 Views
Last Modified: 2015-02-17
I have a 2811 router. If I want to use that router as a conf bridge, how many dsp do I need total to support that. I know there is a dsp calculator im just hoping someone could give me an answer since im under time restraints.
0
Comment
Question by:Jobeethemage
2 Comments
 

Author Comment

by:Jobeethemage
ID: 40604506
Currently is has a pvdm2 - 16
0
 
LVL 20

Accepted Solution

by:
José Méndez earned 500 total points
ID: 40606976
Your own gateway will calculate that for you. First configure the IOS and at some point during the config it will tell you how many conference sessions you can get:

Router2(config)#voice-card 0
Router2(config-voicecard)#dsp services dspfarm

Router2(config)#dspfarm profile 1 conference
Router2(config-dspfarm-profile)#codec g711ulaw
Router2(config-dspfarm-profile)#codec g711alaw
Router2(config-dspfarm-profile)#codec g729ar8

Router2(config-dspfarm-profile)#maximum sessions ?

by using the '?' mark the router will return how many sessions it can support. Each session with up to 8 conference participants.
0

Featured Post

Highfive + Dolby Voice = No More Audio Complaints!

Poor audio quality is one of the top reasons people don’t use video conferencing. Get the crispest, clearest audio powered by Dolby Voice in every meeting. Highfive and Dolby Voice deliver the best video conferencing and audio experience for every meeting and every room.

Join & Write a Comment

There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
As companies replace their old PBX phone systems with Unified IP Communications, many are finding out that legacy applications such as fax do not work well with VoIP. Fortunately, Cloud Faxing provides a cost-effective alternative that works over an…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

708 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now