Solved

Is CE in MPLS the same thing with CPE ?

Posted on 2015-02-15
4
1,383 Views
Last Modified: 2015-02-15
Dear All

As we know, CPE is Customer-premises equipment. But in MPLS, I also see CE router. Is CE the same thing with CPE ? Thanks
0
Comment
Question by:eemoon
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
  • 2
4 Comments
 
LVL 50

Assisted Solution

by:Don Johnston
Don Johnston earned 500 total points
ID: 40611170
One of those "depends on who you're talking to" situations.

CE could be Customer Edge or some use it as simply Customer Equipment.  In most scenarios (at least in the MPLS arena) the two terms are synonymous.
0
 

Author Comment

by:eemoon
ID: 40611174
Thank you for your fast reply.  I think you are right

Usually CE router is connected to PE router where there are a lot MPLS configuration. Do you think the PE router is also located at custom site in many situations ?
0
 
LVL 50

Accepted Solution

by:
Don Johnston earned 500 total points
ID: 40611184
The PE router could be located at the customer's site. It depends on the provider and the situation. Most of the times (in my experience) the PE router is at the provider location.
0
 

Author Closing Comment

by:eemoon
ID: 40611185
Thank you!
0

Featured Post

Free Tool: Port Scanner

Check which ports are open to the outside world. Helps make sure that your firewall rules are working as intended.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

730 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question