asked on
Enable Milticast support on HP NC373i Multifunction Gigabit Server Adapter NIC for WNLB
Hi Guys
Could anyone tell me how to enable milticast support on HP NC373i Multifunction Gigabit Server Adapter NIC for WNLB (2 x Server 2008r2 with single NICs on each one)
Do i need to change any NIC device properties or will they just function if i set up NLB in Multicast mode?
Thanks
Mihail
Could anyone tell me how to enable milticast support on HP NC373i Multifunction Gigabit Server Adapter NIC for WNLB (2 x Server 2008r2 with single NICs on each one)
Do i need to change any NIC device properties or will they just function if i set up NLB in Multicast mode?
Thanks
Mihail
Networking Hardware-OtherNetworkingWindows Server 2008
Last Comment
giltjr
ASKER CERTIFIED SOLUTION
THIS SOLUTION ONLY AVAILABLE TO MEMBERS.
View this solution by signing up for a free trial.
Members can start a 7-Day free trial and enjoy unlimited access to the platform.
ASKER
i cant telnet to the VIP from another server on the same subnet (port 443). Although i can ping both the VIP and the dedicated addresses. any suggestions?
You should not be able to telnet to port 443 successfully. Port 443 is typically what a HTTP/Webserver listens on for SSL/TLS connections. Telnet does not understand TLS/SSL. So when you telnet to port 443, you will most likley get nothing, then if you press enter a couple times, you will get disconnected.
On top of that, attempting to connect to a specific IP address has nothing to do with multicast.
On top of that, attempting to connect to a specific IP address has nothing to do with multicast.