I am planning an IP Phone firmware upgrade...It needs to be done on a specific floor first (as a pilot test) ... This floor has about 12 switches .... If I do show cdp neighbour detail on any of the switches, it shows me detailed stats (example below) .. What I'm interested only is in the Phone's MAC field, Phone Type field and its Version..
cdp neighbors detail
Device ID: SEPxxxxxxxx
IP address: 10.x.x.x
Platform: Cisco IP Phone 7962, Capabilities: Host Phone Two-port Mac Relay
Interface: GigabitEthernet0/3, Port ID (outgoing port): Port 1
Holdtime : 120 sec
Second Port Status: Up
I just need to know SEPxxxxxxx, 7962 and SCCP42.9-2-3S ... Can you suggest a command that I can use to so it pipes the result of show cdp neighbour detail to filter just the 3 fields I'm interest in ? i..e MAC, Device Type and Firmware.
Otherwise lot of manual work in excel ...