Rick_Penney
asked on
Cisco 3560 DHCP Reservation
Hi, I have a DHCP pool setup on a Cisco 3560 with a range of ip's excluded and the network, default router and dns server setup.
I want to reserve 5 of the excluded ip addresses to 5 devices using their MAC addresses.
I only seem to be able to set one reservation.
I have added the config as follows
conf t
ip dhcp pool staticaddresses
host <ip address> <subnet mask>
client-identifier 0148.39f1.0932.8c
1. is there any other way of getting to the <dhcp-config> prompt without typing conf t then ip dhcp pool staticaddresses as I have that listed twice now in my config?
2. When I add additional hosts and client-identifiers to the config either manually or copying and pasting them in one go, it only retains the last entry
kind regards, Rick
I want to reserve 5 of the excluded ip addresses to 5 devices using their MAC addresses.
I only seem to be able to set one reservation.
I have added the config as follows
conf t
ip dhcp pool staticaddresses
host <ip address> <subnet mask>
client-identifier 0148.39f1.0932.8c
1. is there any other way of getting to the <dhcp-config> prompt without typing conf t then ip dhcp pool staticaddresses as I have that listed twice now in my config?
2. When I add additional hosts and client-identifiers to the config either manually or copying and pasting them in one go, it only retains the last entry
kind regards, Rick
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thank you
You're welcome!
ASKER
that worked great, easy when you know how
thanks again
Rick