Webcc
asked on
Wireless configuration on a Cisco 881W
Have the wired configuration up and running, problem is with getting the wireless configured. First reset to default-config and then tried connecting from the cli using "service-module wlan_ap 0 session" which stated that it needed an IP address.
Assigned an ip address to the wlan_ap0 interface and when I connect I get the following prompt "ap:" instead of "ap>" or "ap#".
So the problem is getting into configuration mode for the AP.
Assigned an ip address to the wlan_ap0 interface and when I connect I get the following prompt "ap:" instead of "ap>" or "ap#".
So the problem is getting into configuration mode for the AP.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER