operationsIT
asked on
Cisco 2960 to Netapp interface up but switch can't ping
Does anyone have cisco interface to netapp fas2020 willing to share. Replaced HP and now can't access Netapp. Netapp on vlan 8 and router is configured with vlan 8 gateway but can't ping netapp from switch it's connected to
ASKER
#Auto-generated by setup Sat Mar 30 02:04:04 GMT 2013
hostname ussiua00011
ifgrp create lacp onegig-sw1 -b ip e0a e0b
ifgrp create lacp onegig-sw2 -b ip e0c e0c
ifgrp create single onegig onegig-sw1 onegig-sw2
ifgrp favor onegig-sw1
vlan create onegig 1 899
ifconfig onegig-1 `hostname`-onegig-1 mediatype auto netmask 255.255.255.0 partner onegig-1 mtusize 1500
ifconfig onegig-899 `hostname`-onegig-899 mediatype auto netmask 255.255.255.0 partner onegig-899 mtusize 1500
route add default 10.102.8.1 8
routed on
options dns.domainname sickcn.net
options dns.enable on
options nis.enable off
savecore
hostname ussiua00011
ifgrp create lacp onegig-sw1 -b ip e0a e0b
ifgrp create lacp onegig-sw2 -b ip e0c e0c
ifgrp create single onegig onegig-sw1 onegig-sw2
ifgrp favor onegig-sw1
vlan create onegig 1 899
ifconfig onegig-1 `hostname`-onegig-1 mediatype auto netmask 255.255.255.0 partner onegig-1 mtusize 1500
ifconfig onegig-899 `hostname`-onegig-899 mediatype auto netmask 255.255.255.0 partner onegig-899 mtusize 1500
route add default 10.102.8.1 8
routed on
options dns.domainname sickcn.net
options dns.enable on
options nis.enable off
savecore
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Were you able to resolve this on the HP switch? If you need help let me know, you can always use the serial port or ssh/telnet and use the menu based options to configure, it's fairly straightforward
can you provide the rc file output from the Netapp?