Link to home
Start Free TrialLog in
Avatar of Eprs_Admin
Eprs_AdminFlag for Austria

asked on

Robocopy error

Hi Experts,

tonight I started a long copy job of over 600GB.
After hours ROBOCOPY wrote errors:

error 112 (0x00000070)

I want to copy from my old fileserver to my new NETAPP.
250GB are copied so far, then the error came up.
I have more than 1,6 TB space left on this volume on my NETAPP.
All Partitions are NTFS.
This is my command:
robocopy D:\source\ \\target\ /mir /copyall /njh /v /Z /R:5 /W:1 /DCOPY:T

Open in new window

Can you help me to solve this error ?
Avatar of NVIT
Flag of United States of America image

Do you have Quotas enabled on any folder(s)?
it tells you there is not enough space
i would run a diag on the drive, followed by a chkdsk
Avatar of Eprs_Admin


no quotas enables on target or source
the target drive is my NETAPP with my cifs

2015/06/24 00:26:05 FEHLER 112 (0x00000070) Folgende Datei wird kopiert D:\ASE_WG\V2_WW\Archive\H259KMXI0EE9KA2593XNQ7X5

Open in new window

Maybe the issue has to do with this TMP inside the filename ?
Avatar of NVIT
Flag of United States of America image

Link to home
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
this is one filename

Avatar of zalazar

Are there maybe NetApp snapshots on the destination volume ?

I also did some tests with this filename but can't see any issues.
You might look on the NetApp disk in the same directory of where the file should be and execute command "dir /x" to see if there are files which have a 8.3 name like H259KM~1.JPG
I spoke to the NETAPP support and we changed the filename to a shorter name.
Now I can copy the files.
This is no robocopy issue, its NETAPP.