Link to home
Start Free TrialLog in
Avatar of Ken Herr
Ken HerrFlag for United States of America

asked on

Cannot pull IP addresses on Engenius Neutron switch

I have an Engenius Neutron EWS5912FP wireless controller/switch that I am trying to configure three vlans on.  The Engenius switch is connected to a Cisco SG220 layer 2 switch which is connected to a Cisco SG300 layer 3 switch.  The vlans are set up to pull DHCP addresses from the SG300.  The ports on the SG220 are configured to pass the vlans and other devices are able to get IP addresses from the SG300.  However, the Engenius switch and the attached WAPs are unable to pull IP addresses from the SG300.  Several of us have looked at the configuration and cannot see anything out of order.

Does anybody have direct experience in a similar configuration of Engenius and Cisco devices?
SOLUTION
Avatar of F P
F P
Flag of United States of America image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
ASKER CERTIFIED SOLUTION
Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
SOLUTION
Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
SOLUTION
Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of Ken Herr

ASKER

my own comment was just to give feedback about the steps taken without resolving the problem.  It appears that this is a manufacturer problem