robbie999
asked on
Attach a hyper -v host manually to SCDPM 2012
I have mapped a network drive to the agents path and installed the agent on the server
I have run the setdpmserver command on the target machine and this completes successfully
However within DPM i get the following error message when i try to attach the server
Data Protection Manager Error ID: 307
The protection agent operation failed because DPM detected an unknown DPM protection agent on srv-p1.domain.local.
Use Add or Remove Programs in Control Panel to uninstall the protection agent from srv-p1.domain.local, then reinstall the protection agent and perform the operation again.
I have tried to reinstall once and this has not worked
Kind regards
I have run the setdpmserver command on the target machine and this completes successfully
However within DPM i get the following error message when i try to attach the server
Data Protection Manager Error ID: 307
The protection agent operation failed because DPM detected an unknown DPM protection agent on srv-p1.domain.local.
Use Add or Remove Programs in Control Panel to uninstall the protection agent from srv-p1.domain.local, then reinstall the protection agent and perform the operation again.
I have tried to reinstall once and this has not worked
Kind regards
Maybe this will help.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Because it was me that found the answer