kskr_networks
asked on
Public IP to Public IP NAT
Hi,
We are using Public IPs inside our networks due to some legacy network in place,we have a team of users who use this public IP while going out ,I would like to hide and NAT these as one Public IP while going out.
I have done NAT from Private to Public which is common scenario in any organisation.
Can someone guide on this on Public to Public NAT, ( I will be doing this on a Cisco FWSM )
We are using Public IPs inside our networks due to some legacy network in place,we have a team of users who use this public IP while going out ,I would like to hide and NAT these as one Public IP while going out.
I have done NAT from Private to Public which is common scenario in any organisation.
Can someone guide on this on Public to Public NAT, ( I will be doing this on a Cisco FWSM )
It's just the same. They're just numbers.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Basically I would say PAT as I have group of 6 users using the Public IPs inside LAN and I would like to Hide these IPs under one public IP while going out.
I prefer NAT and then PAT overload when there are insufficient addresses in the pool.