Rhala
asked on
what's required to create encrypted trunk with Cisco call manager
Dear All,
I need to create a new TLS trunk between Lync 2013 and Cisco Call Manager, i would like to ask about the requirements, usually when i do TCP trunk, nothing required, only the same port in Lync and Call Manager, but using TLS is it the same?
Please Help
I need to create a new TLS trunk between Lync 2013 and Cisco Call Manager, i would like to ask about the requirements, usually when i do TCP trunk, nothing required, only the same port in Lync and Call Manager, but using TLS is it the same?
Please Help
Page 22
Set SIP Trunk Security Profile Information
In the SIP Trunk Security Profile Information section, specify the following settings as shown in figure 15:
• Set Device Security Mode to Encrypted. This ensures that CUCM uses TLS to communicate with the Mediation Server.
• Set Incoming Transport Type to TLS.
• Set Outgoing Transport Type to TLS.
• Set Incoming Port to 5061.
Set SIP Trunk Security Profile Information
In the SIP Trunk Security Profile Information section, specify the following settings as shown in figure 15:
• Set Device Security Mode to Encrypted. This ensures that CUCM uses TLS to communicate with the Mediation Server.
• Set Incoming Transport Type to TLS.
• Set Outgoing Transport Type to TLS.
• Set Incoming Port to 5061.
ASKER
thanks, but what i do in Lync side?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
This dodo keeps asking stupid questions and never marks an answer as an accepted solution. Please do not waste your time on him.
http://go.microsoft.com/fwlink/p/?LinkId=221459