spmt
asked on
CHANGE NETMASK OF DMZ ZONE ON ASA 5510 FAILOVER
Hi , i have two asa 5510 configure in failover active/standby , i need change netmask address of my DMZ zone , did i need to break failover and make change the netmask of DMZ zone and make failover again ? . Or can i change the netmask address of the DMZ zone on the active one and save to synchronize the standby without problem ?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.