Mongo Peck
asked on
VLAN and PC GAteway Sanity Check
Just wanted to ask a question for a quick sanity check .... I'm at the point I've over thought it so I'm doubting the basics.
I have a bunch of users (USERS A 10.0.0.x / 24) that connect to a MPLS router (10.0.0.250) via a Layer 2+ switch on a default VLAN.
Their default Gateway on the NIC's (Static and DHCP) is set to 10.0.0.250
I wanted to add another bunch of users (USERS B 10.1.1.x /24) that connect to another VLAN (VLAN 3) on the same switch that are totally independent and go out via another broadband router.
My plan was to leave half the switch (TOP) as default with the MPLS and users connected to these ports with these users still keeping the
same default gateway etc.
Create a new VLAN on the bottom half of the switch (VLAN 3) and connect the users and broadband to the bottom ports and set their
default gateway to the IP Address of the Broadband router (10.1.1.250 /24)
Both VLANS would not have any static routes added.
Can you see and problems ?
PS
At a later date change the users from default VLAN to a new VLAN 2
I have a bunch of users (USERS A 10.0.0.x / 24) that connect to a MPLS router (10.0.0.250) via a Layer 2+ switch on a default VLAN.
Their default Gateway on the NIC's (Static and DHCP) is set to 10.0.0.250
I wanted to add another bunch of users (USERS B 10.1.1.x /24) that connect to another VLAN (VLAN 3) on the same switch that are totally independent and go out via another broadband router.
My plan was to leave half the switch (TOP) as default with the MPLS and users connected to these ports with these users still keeping the
same default gateway etc.
Create a new VLAN on the bottom half of the switch (VLAN 3) and connect the users and broadband to the bottom ports and set their
default gateway to the IP Address of the Broadband router (10.1.1.250 /24)
Both VLANS would not have any static routes added.
Can you see and problems ?
PS
At a later date change the users from default VLAN to a new VLAN 2
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.