lianne143
asked on
How to configure and add AIR-CAP26021-E-K9(Cisco wireless access point) to associate with Cisco 4400 Wireless LAN controller
Hi
We have Cisco 4400 Wireless LAN controller in our network. We are using 10 Cisco Aironet AIR-LAP1142N-E-K9 connected at different locations in our organisation and my predecessor had configured and set up this.
I wanted to add more wireless access point , so I asked my supplier to supply me with 3 numbers of same model access point (AIR-LAP1142N-E-K9 ), but they have sent me AIR-CAP26021-E-K9.I thought if I connect this access point to the controller it will take the IP from the DHCP and configure itself.
When I connected to the network , it boots and the orange light keeps flashing continuously.. Normally with (AIR-LAP1142N-E-K9) when I disconnect and connect it back it boots and after few minutes the led goes blue( confirms the Wireless Access point has successfully associated with the controller).
I have not set up this type of WAP in the past, please post me some tutorials as how to associate the new wireless access points (AIR-CAP26021-E-K9) with the controller.
Any help much appreciated
Thanks
We have Cisco 4400 Wireless LAN controller in our network. We are using 10 Cisco Aironet AIR-LAP1142N-E-K9 connected at different locations in our organisation and my predecessor had configured and set up this.
I wanted to add more wireless access point , so I asked my supplier to supply me with 3 numbers of same model access point (AIR-LAP1142N-E-K9 ), but they have sent me AIR-CAP26021-E-K9.I thought if I connect this access point to the controller it will take the IP from the DHCP and configure itself.
When I connected to the network , it boots and the orange light keeps flashing continuously.. Normally with (AIR-LAP1142N-E-K9) when I disconnect and connect it back it boots and after few minutes the led goes blue( confirms the Wireless Access point has successfully associated with the controller).
I have not set up this type of WAP in the past, please post me some tutorials as how to associate the new wireless access points (AIR-CAP26021-E-K9) with the controller.
Any help much appreciated
Thanks
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
please post me tutorials to put in autonomous mode and install in standalone mode
thanks
thanks
ASKER