retokasser
asked on
Exchange 2013 DAG EDB in DirtyShutdown
We are running an ready to go live Exchange 2013 environment, while troubleshooting problems with Dell caused by AppAssure I discovered the following situation. We run a DAG with 2 server and 4 EDBs (2 active and 2 passive on each server). When we shut down the Exchange Information Store service on server 1 and cause the two active EDBs to fail over to server 2, it works just fine. Running the command "eseutil /mh <EDB-PATH>" now shows a clean shutdown state on the previously active EDBs on server 1 and a dirty shutdown state on the passive EDBs. After starting the Exchange Information Store service you can manually failover every EDB to server 1 without an issue...
Is this behavior normal?
Is this behavior normal?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.